System Configuration and Setup 2-7
Battery Handling
Keep the following in mind when removing or replacing a battery.
Use only the battery designed for your system in the NEC Versa. Mixing
other manufacturer’s batteries, or using a combination of very old and
new batteries can deteriorate battery and equipment performance.
Turn off power to the system after use. Keeping system power on can
degrade battery performance and shorten battery life.
Clean the battery terminals with a dry cloth when they get dirty.
Keep the battery out of the reach of children.
Replacing the Battery
Replace the battery pack installed in your NEC Versa system as follows.
Note:
Use the batteries in the NEC Versa computer for
which they are designed. Also, installing another
manufacturer’s battery, or using a combination of very old
and new batteries can deteriorate battery and equipment
performance.
1. Save your files, exit Windows, and put your system into Suspend mode or
turn off system power.
2. Close the LCD and turn the system over.
3. Slide the battery release latch toward the back of the system and hold firmly.
Battery Bay Release Latch
A
– Battery Bay Release Latch
To Next Page
Loading...
