NEC Versa LX - Checking;Setting System Parameters

2-14 System Configuration and Setup
Checking/Setting System Parameters
See the following table for a list of parameters, their factory default settings, and
alternate settings. A description of each setting follows the table.
To reset all parameters to the default settings, select Auto Configuration with
Defaults from the BIOS Setup Main Menu and highlight Yes and press
Enter
.
BIOS Setup Parameters
Parameter Default Setting Alternate Setting(s)
Standard CMOS Setup
Date mm/dd/yyyy
System Memory (automatically detected)
System Time hh/mm/ss
Diskette Drive A 1.44 MB, 3.5 inch Not installed/1.44 MB
Diskette Drive B
1,8
Not installed 1.2 MB, 5.25; 1.44 MB, 3.5 inch
Internal Auto User Defined, CDROM
SuperDsk, Not installed
32-Bit Mode On Off
VersaBay Auto CDROM User Defined, CDROM
SuperDsk, Not installed
32-Bit Mode On Off
Docking Station IDE
1
Auto User Defined, CDROM
SuperDsk, Not Installed
DS Internal
1
Auto User Defined, CDROM
SuperDsk, Not Installed
DS VersaBay
1
Auto User Defined, CDROM
SuperDsk, Not Installed
Boot Sector Virus Protection
8
Disabled Enabled
Advanced CMOS Setup
Video Out Type NTSC PAL
LCD Panel View Expansion On Off
PS/2 Port Warm Swap Enabled Disabled
Internal Mouse Enabled Disabled
Graphics Aperture Size
8
256 MB 4 MB, 8 MB, 16 MB, 32 MB,
64 MB, 128 MB
System Security Setup
Change Supervisor
Password
Press Enter
Change User Password
2
Press Enter
Boot Password Required
3
No Yes
Resume Password Required
3
No Yes