NEC Versa LX - Windows NT

Disassembly and Reassembly 3-13
4.
Once the drive is disconnected, use the lever to lift the drive out of the
system. Once removed, only handle the drive by its sides.
Lifting the drive out of the bay
Front Cover
The following describes the steps to remove the front cover.
1.
The file bay retaining screw (
B
) on the bottom of the system should have
been removed in a prior step. If not, remove it now.
2.
Remove a total of 9 screws.
 5 from the bottom surface (
A
)
 1 from the VersaBay III (
A
)

1 from the file bay (
A
)
 2 from the battery bay (
A
)
A
– Bottom Screws
B
– File Bay Screw
3.
Turn the system over and open the LCD panel.