Disassembly and Reassembly 3-19
3. Slide the fan duct away from the fan to remove.
4. Remove two screws to release the fan from the bracket.
CPU Assembly
If the CPU assembly was not removed, as described earlier you can remove it
now as described next.
1. Turn the main board over so the bottom is facing up.
2. Remove three screws.
3. Lift and disconnect the CPU assembly from the main board. The heat shield
and CPU board come off as two layered pieces.
Bracket/Insulator Assemblies, Bridge Battery, Power Switch
1. The bridge battery (
A
) is now accessible on the bottom assembly.
2. To remove the Power switch, simultaneous slide it to the front and gently lift
the Power switch from the bottom assembly.
3. Remove both Bracket/Insulator assemblies by removing four screws (
B
) and
lifting the Bracket/Insulator assemblies from the bottom assembly.
A
– Bridge Battery
B
– Bracket/Insulator Assembly Screws
Connector Board, Switch/Cable Cover, Switch/Cable
1. Remove one screw (
A
) to release the switch/cable cover.
2. Lift the switch/cable cover.
3. Disconnect the cable at connector CP8 (
B
) on the connector board and lift
the switch/cable from the two locating pins.
To Next Page
Loading...
