NEC Versa LX - Bottom Base Assembly; Reassembly

Disassembly and Reassembly 3-29
4. Remove one screw (
A
) to release the connector board from the bottom
assembly.
A
– Screws
B
– Connector CP8
Bottom Base Assembly
There are doors and tilt feet on the bottom assembly.
 All doors snap in and out.

To remove the tilt feet open the foot and slightly compress the four
sections together and snap out.
Reassembly
Reassembly is the reverse of the disassembly process. Use care to insure that all
cables and screws are returned to their proper positions.