NEC Versa LX - SystemSoft PowerProfiler

Disassembly and Reassembly 3-23
Speaker Assembly, VersaGlide Assembly, LCD Panel Latch Switch Assembly
1. Position the front cover assembly as shown in the following illustration.
A
– Screws
2. Remove the speaker assembly by removing 6 screws. Lift the speaker
assembly from the front cover assembly.
VersaGlide Assembly
Remove the VersaGlide and cable assembly instructions as follows.
1. Disconnect the LCD panel switch cable from connector CP16 (
A
) on the
VersaGlide assembly.
2. Remove the four screws (
B
).
3. Lift the VersaGlide assembly from the front cover assembly.
A
– Connector CP16
B
– Speaker Assembly Screws
LCD Panel Switch Board
Remove the LCD panel switch boards instructions as follows.
1. Disconnect the LCD panel switch cable from connector CP17 (
B
) on the
LCD panel latch switch board.