3-6 Disassembly and Reassembly
3.
Gently lift up the edge of the keyboard nearest the LCD and slide the
keyboard toward the LCD screen to release the tabs that secure it.
Positioning the keyboard
4.
Carefully turn over the keyboard and place it face down on the VersaGlide.
Be careful not to twist the keyboard cable. Remove the keyboard cable from
the main board by pulling up on the inserts on both sides of the cable
connector.
To remove an installed SO-DIMM, follow these instructions.
Press the locking tabs away from the sides of the SO-DIMM and hold
while gently lifting on the edge of the SO-DIMM.
When the edge of the SO-DIMM pops up and is at approximately a 60
degree angle, pull the SO-DIMM from the socket.
Removing an installed SO-DIMM
To Next Page
Loading...
