The two threads must be inserted separately, one in each of
the two thread guides " M " and " N " on the needle clamp.
Fig. 4
To disconnect the “Automatic"'.
This operation has to be done when the machine is at a
standstill.
Turn the design regulating knob clockwise until the square mark
(*) is in line with the mark above this knob.
Turn the balance wheel for one full turn, toward you.
Turn the design regulating knob clockwise again, until the triangle
sign and the mark above the knob are in line (Stop).
The “Automatic " is now completely disconnected.
To Next Page
Loading...
