16 Warnings and error messages
16.1 Warnings PRIMUS 2 HVA2N
Warnings always indicate particular or special operating circumstances. The
red LED of the display panel and the warning symbol
m
in the display flash
with the display of the warning.
To reset the warning, use the
button to switch the laser Off and then back
On again or use the
button to switch to MANUAL operating mode.
Display Description of the warning
C00
Laser is tilted by more than ±5° and cannot horizontally level itself.
C01
TILT alarm - The laser was vibrated after 30 seconds expired.
C02
Time exceeded during automatic levelling.
C03
Unallowed change in horizontal position W X vertical position.
C04
Error while operating AUTOALIGN (appears on the display
of PRIMUS 2 HVA2N)
ERR AA
Error while operating AUTOALIGN (appears on the display
of PRIMUS 2 HVA2N)
16.2 Error messages PRIMUS 2 HVA2N
Display Description of the error message
ERR1 – ERR11
Internal device error X Send laser to NEDO's Service department.
ERR12
If this error occurs more than once, X Send laser to NEDO's Service
department.
16.3 Error messages COMMANDER 2 HVA2N
Display Description of the error message
ERR9 – ERR11
Internal device error X Send COMMANDER 2 HVA2N to NEDO's
Service department.
NOTE
The threshold of the TILT alarm function can be switched between COARSE, FINE and
OFF by NEDO or a service partner. It is therefore possible to deactivate the TILT alarm.
By default, the COARSE threshold is set.
To Previous Page
Loading...
