16
Chapter 2 . Basics
Enroll a fingerprint for the first time
For added security and to ensure that you can still access your data if your phone fails to recognize
your fingerprint, you will need to set a backup screen lock method when configuring fingerprint
unlock.
1. Go to Settings > Screen lock, fingerprint & security > Fingerprint.
2. Select Fingerprint + Pattern or Fingerprint + PIN or Fingerprint + Password, and then follow the
onscreen instructions to set a screen lock password.
3. Once you have configured the password, tap Add fingerprint.
4. Place your fingertip on the fingerprint sensor. Press down lightly on the sensor until your phone
vibrates. Repeat this step using different parts of your fingertip until your phone has successfully
added your fingerprint.
5. Once you have added your fingerprint, tap OK.
Note:
1. When recording your fingerprint, make sure the fingerprint sensor and your fingers are dry and clean.
2. For more security settings, see Screen lock, fingerprint and security.
Add, delete or rename your fingerprint
Add multiple fingerprints to make it easier to unlock your phone. You can also delete or rename
your fingerprints.
1. Go to Settings > Screen lock, fingerprint & security > Fingerprint.
2. Enter the screen lock pattern/password/PIN.
3. In the Fingerprint list section, you can:
• Add a fingerprint: Tap Add fingerprint to add a new fingerprint. You can add up to five in total.
• Rename/delete a fingerprint: Tap a previously added fingerprint to rename or tap to delete
it.
4. After you enter several fingerprint, there is a list showing all the recorded fingerprint. When you
place your fingertip on the fingerprint sensor, the corresponding place turns grey, which helps
you easily find the fingerprint.
2. 10 Configure your face data
Use the facial recognition to unlock your phone.
After waking up your phone screen, you can unlock your phone by looking at the screen.
Add your face data for the first time
For added security and to ensure that you can still access your data if your phone fails to recognize
your face data, you will need to set a backup screen lock method when configuring fingerprint
unlock.
1. Go to Settings > Screen lock, fingerprint & security > Facial recognition, and choose the
appropriate method to add face data.
• If you have set a pattern, PIN, or password as the screenlock method, enter the screenlock
method.
• If you have not set a pattern, PIN or password as the screenlock method, select one and
follow the onscreen instructions to complete.
2. Tap Add face data and follow the onscreen instructions to register your face data and enable
the facial recognition. Then you can use facial recognition to unlock your phone.
To Next Page
Loading...
