19
Chapter 3 . Connection
• Manage peer device and remembered groups
On WLAN direct screen, you can view your Peer devices and Remembered groups. Tap a peer
device and tap OK to disconnect. Tap a remembered group and tap OK to forget the group.
Advanced WLAN settings
Go to Settings > WLAN > > Advanced, you can configure these settings:
• Saved networks: Tap Saved networks to view the networks remembered by your device. Tap a
network and tap FORGET to forget it.
• Turn on WLAN automatically: Turn on the switch and WLAN will turn back on near high-quality
saved networks, like your home network.
• Open network notification: Turn on the switch to enable notifying when a high-quality public
network is available.
• Install certificates: Tap Install certificates to and follow the onscreen instructions to install
certificates.
• Choose network rating provider: Tap to choose the provider of network rating. Google is the
default provider. You can also choose None to choose network rating.
• View MAC and IP address: On the Advanced, you can view your MAC and IP address.
3. 2 Mobile data
Before using mobile data, ensure that you have a data plan with your carrier to avoid incurring
excessive data charges.
Connect to mobile data
You can connect to mobile data in following three ways:
• Swipe down from the status bar to open the Quick Settings Panel and tap . When it lights up,
mobile data is enabled.
• Swipe down from the status bar to open the Quick Settings Panel. Touch and hold to enter
the mobile data settings. Turn on the Mobile data switch.
• Go to Settings > Dual-SIM & network and switch on Mobile data.
Note:
1. If a WLAN connection to the internet isn’t available, apps and services may transfer data over your carrier’s
cellular network, which may result in additional fees. Contact your carrier for information about you mobile
data plan rates.
2. When you don’t need to access the internet, disable mobile data to save battery power and reduce data
usage.
3. 3 Connect to computer
Transfer the data on your phone to your computer or transfer the data on your computer to your
phone.
When you use a USB cable to connect your phone with a computer or another device, Allow access
to device data will be displayed in a popup dialog. Tap ALLOW to allow file transfer between your
phone and the computer. Tap DENY to deny data connection and charge only.
Select the USB connection mode
Swipe down from the status bar to open the Notification Panel, and then tap the USB connection
notification. You can choose from the following USB connection modes:
• File Transfer: Transfer files between your phone and the computer.
To Next Page
