EasyManua.ls Logo

Nelson N800iTM - Page 82

Nelson N800iTM
142 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Stud welding unit N800i
As of 24.08.2021
Manual part number: BE 1221
79
Tucker GmbH, Mail / Post: Max-Eyth-Str.1, 35394 Gießen, Germany
F
code
Description
Possible Values
Default
Unit
Notes
F19
Lock Mode
1 to 3
1
x
Mode 1: Use the lock key to toggle blocking on all keys - no
password protec- tion. Mode 2:
Use the lock key to enter a password, lock key as ‘enter’. From
there, all keys are blocked until you press lock again. It will prompt
for the same password entered when originally locked. Pass-
word can be up to 9 characters. Mode 3: Same as mode 2, except
user can tog- gle between presets and cannot change the value of
presets. Mode 4: Same as mode 3 except the user can adjust the
time and current by a percentage as set by F57.
F20
Debug
ENTER DEBUG
MODE
ENTER
DEBUG
MODE
x
Used by manufacturing and service.
F21
User Counter
0 to 4.3B
0
Welds
While in this F code, press and hold the time-down button 3-5
seconds to reset the counter.
F22
Total Counter
0 to 4.3B
0
Welds
(Non-resettable)
F23
Chuck Stripper
OFF ON
OFF
x

Table of Contents

Related product manuals