Nelson N800iTM - Page 83

Stud welding unit N800i
As of 24.08.2021
Manual part number: BE 1221
80
Tucker GmbH, Mail / Post: Max-Eyth-Str.1, 35394 Gießen, Germany
F
code
Description
Possible Values
Default
Unit
Notes
F24
Stud Expert Mode
Unit Selection
English, Metric oder
Both
English
x
Lets user select which units are dis- played as stud sizes while in
Stud Ex- pert mode. This defaults to English with 2-wire gun
interfaces and Metric with 4-wire gun interfaces.
F25
Software Versions
A: DSP version B:
Coldfire version
A: DSP
version
x
Time-up/down to see both versions
F26
Restore Factory
De- faults
HOLD TIME DOWN
BUT- TON
HOLD
TIME
DOWN
BUT-
TON
x
While in this F code, press and hold the time-down button to reset all
F codes to default.
F27
Scroll Speed
100 to 500
150
ms
Controls text scrolling speed
F28
Pilot Arc Extension
0 to 10
0
ms
This is the time the control will wait to start the main arc after
establishing a stable pilot arc.
F29
Chuck Change
Counter
OFF to 1000000
OFF
Welds
Increments by 1000; Press down key until value equals OFF to
disable. This function counts down and turns the chuck change
indicator ON when it re- aches zero.
F30
Short Cycle Mode
OFF ON
OFF
X
Turn this on to limit weld time to 100ms. This is automatically turned
on when ‘stud feed’ is enabled, but not au- tomatically turned off.
Changing this mode affects other F codes. See section on ‘which F
codes change automatically’.