NEOX User manual - Edition 03-201616
• Stop and inspect the proper set up of your newly purchased bike, so as to more easily
recognize any anomalies at a later time
• If any defects are detected during these inspections, immediately contact your dealer.
• You can use your bike again only when it is safe.
Before each check, make sure that your bike is switched o and is not connected to
the power supply, so that you do not inadvertently start it.
CHECKLIST OF CONTROLS
TO PERFORM BEFORE EACH USE
• Check that all the parts are properly mounting.
• The hub of the wheel assembly should not move on the front fork or rear single arm fork.
• The lever of the quick unfasten on the wheels have to be closed and the closing knob
on the rear wheel have to be fixed and with the security lock closed.
• check the xing of the security block (A) on the closing knob.
• You don’t have to hear squeaks or creackings.
• Check the tyre pressure.
• Check the position of the valve which must be perpendicular with respect to the hub
and not tilted.
• Verify the absence of external damage, foreign bodies and wear on the tyres:
• The entire surface of the tyre must still have the original tread pattern.
• It should not be possible to see the section of the tyre that is located under the layer
of rubber.
• There should be no dents, cracks, cuts or damage.
• Remove any foreign bodies (thorns, small stones, bits of glass, etc.) by hand or using
a small tool without spikes or blades.
CLOSE
CLOSE
A
To Next Page
Loading...