NEOX User manual - Edition 03-201640
hoW to use the Battery charger
1. Be sure that connections are in good conditions and not damaged by improper
strength or use.
2. Insert the plug (1) of the power set in a socket AC 220 Volt. If the plug is inserted in
the socket at 220 Volt AC without the battery connected with the power set, the two
leds Power Red and Charge Green will turn on as the unit is in stand by.
3. Connect the connector (2) to the battery out of power; the green light becomes red.
4. The Charge Led becomes green when the battery is completely charged. When the
battery is completely charged, remove plugs 1 and 2 from the power set and remove
the battery.
These instructions are also contained inside the battery charger packaging.
• The first time the battery must be recharged for at least 7 hours.
• For the first 5 uses completely charge the battery and then fully discharge it. This
will ensure the maximum performance of the battery pack.
• Fully charge the battery before long stops.
• Do not store the e-bike for long stops with the battery uncharged.
characteristics of the Battery charger
Input voltage: 100-240V AC
Frequency: 57-63Hz
Absorbed current: 1.5A
Output voltage: 36V DC
Maximum current output: 2A
• While charging a red light is lit on the battery charger. When this light turns green,
charging is completed.
• During charging place the battery charger in a horizontal position and in a ventilated
environment which is not exposed to direct sunlight.
• Never charge in the vicinity of liquids, whether they are flammable or not.
• Do not place the battery charger and the cord in water or in places with high humidity.
• If the charger is subjected to large fluctuations in temperature, wait 30 minutes
prior to use.
01
02
To Next Page
Loading...