The settings can also be used to
designate the primary (HI) and
secondary (LO) meters in a dual set
application.
Programming the HI Register
Complete the following steps using the Neptune field
programmer to select the ProRead Program tab for
programming.
1. Select RF Compound HI
format.
2. Select connectivity 2W.
3. Match the Dial Code 65.
4. Type the appropriate
register ID.
5. Program the register.
6. Read or query the
register to confirm
correct programming as
shown in this figure.
Figure 17: HI Register
- 11 -
To Next Page
Loading...
