Neptune E-CODER User Manual

Figure 16: Cover in Place
10. Snap the cover
closed to finish the
installation.
11. Proceed to "Activating the E-CODER®" on page15.
5: Installing Networked Receptacle /
Dual Port MIUs
Enhanced R900
®
v4 MIUs are not dual
port capable. These instructions apply
only to v3 MIUs.
The Dual Port R900 and R450™ MIUs work only with
Neptune
®
ProRead™ or E-CODER
®
registers. Each
register must be programmed in “RF Network” mode
prior to installation.
E-CODER registers cannot be
programmed while connected together
in a network. Program them separately
before making the network connection.
The designations HI and LO are
Neptune's designations for the high (HI)
flow or turbine side of the compound,
and the low (LO) flow or disc side of the
compound.
- 10 -

Neptune E-CODER Specifications

General

Output	Digital
Power Source	Battery or external power
Operating Temperature	-20°C to 60°C (-4°F to 140°F)
Power Supply	3.6V Lithium Battery
Dimensions	Varies depending on model
Weight	Varies depending on model