Copyright
This manual is an unpublished work and contains the trade secrets and
confidential information of NeptuneTechnologyGroupInc., which are not to be
divulged to third parties and may not be reproduced or transmitted in whole or
part, in any form or by any means, electronic or mechanical for any purpose,
without the express written permission of NeptuneTechnologyGroupInc. All
rights to design or inventions disclosed herein, including the right to
manufacture, are reserved to NeptuneTechnologyGroupInc.
Neptune engages in ongoing research and development to improve and
enhance its products. Therefore, Neptune reserves the right to change product
or system specifications without notice.
Trademarks Used in This Manual
MACH 10
®
and E-CODER
®
are registered trademarks of Neptune Technology
Group Inc. MACH 10
®
)R900i™, and ProRead™ are trademarks of Neptune
Technology Group Inc. Other brands or product names are the trademarks or
registered trademarks of their respective holders.
FCCNotice
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
l This device may not cause harmful interference.
l This device must accept any interference received, including interference that
may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCCRules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate radio
frequency energy, and if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of
the following measures:
l Reorient or relocate the receiving antenna.
l Increase the separation between the equipment and receiver.
l Connect the equipment to an outlet on a circuit different from that to which
the receiver is connected.
l Consult the dealer or an experienced radio / TV technician for help.
To Next Page
Loading...
Need help?
General
