Ness D8 User Manual

NESS D8 V4.7 CONTROL PANEL - USER MANUAL
14
OPERATION
If a detector becomes faulty and cannot be
Sealed when arming the panel, then its zone
may be Excluded so that it does not generate
alarms.
When zones have been Excluded, the EXCLUDE
light fl ashes continuously while the panel is
Disarmed and also when Armed.
Zones can be excluded while the panel is either
Disarmed or Armed. See notes below.
Zone Exclude IS not permanent. Excluded
zones are automatically INCLUDED next time
the panel is Disarmed.
Zones can be manually included by the
same method as Excluding. Simply use the
[ZONE NUMBER]
sequence to turn OFF the
zone lights to be Included.
The zone light of each Excluded zone will turn on The zone light of each Excluded zone will turn on
or... [User Code]
[Zone No.] [Zone No.][Zone No.] [Zone No.]
ENTER
ENTER
ENTER
ENTER
ENTER
or...
Press...Press...
Press... Press...
The
The The
Enter the zone number of the zone/s to be Excluded
to exit Exclude mode to exit Exclude mode
Enter the zone number of the zone/s to be Excluded
Exclude light will turn on
Exclude light will flash continuously
The EXCLUDE icon will turn on
EXCLUDE icon will flash continuously
[User Code]
LED KEYPAD
EXCLUDING ZONES
LCD KEYPAD
NOTES
• EXCLUDE E works only when the panel is Disarmed.
• EXCLUDE [User Code] E works in any state.
• EXCLUDE [User Code] E can only exclude the zones in the Area assigned to that code.

Ness D8 Specifications

General

Brand	Ness
Model	D8
Category	Control Panel
Language	English