Ness D8 User Manual

NESS D8 V4.7 CONTROL PANEL - USER MANUAL
19
* The Primary and Secondary telephone numbers are normally only
used for central station monitoring. These numbers can only be
programmed in Installer Program Mode.
** The Follow Me Telephone Number replaces the Primary AND Second-
ary telephone numbers.
MONITORED
PREMISES
AUDIBLE MONITORING
TELEPHONE LINE ANY TELEPHONE
AUDIBLE MONITORING
The D8 can also be programmed to send audible
messages to any telephone or mobile phone.
When programmed for audible monitoring, the D8 calls
a pre-programmed number (or numbers) and sounds
a series of beeps over the phone. These beeps can
identify the zone or zones which caused the alarm and
well as several other alarm types.
FOLLOW ME TELEPHONE NUMBER
The Follow Me Telephone Number is the telephone
number to which the D8 sends alarm reports when
Audible Monitoring is enabled.
The Follow Me Telephone Number can be changed by
the user in User program Mode.
If the Follow Me Telephone Number is programmed,
the Primary and Secondary telephone numbers
are ignored, even if programmed. (When Audible
Monitoring is enabled).
See page 25 for information on programming the Follow
Me Telephone Number.
AUDIBLE MONITORING SEQUENCE
When triggered by an alarm, the D8 will dial the
programmed telephone number/s and output
the audible message for 45 seconds or until it is
acknowledged.
ACKNOWLEDGING THE ALARM
The person receiving the call can then acknowledge
the alarm by pressing the
key on their telephone.
Press the
key for at least 2 seconds during pauses
in the audible message.
(On mobile phones, press the
key in short bursts.
Many mobile phones enter sub menus if the
key is
pressed continuously).
If the alarm is not acknowledged, the keypad’s LINE
light will flash continuously until the panel is next
Armed.
CENTRAL STATION MONITORING
The D8 control panel has an on-board digital
dialler which can send detailed alarm messages
to a Central Monitoring Station.
The digital messages can include information
about the zone or zones which caused the alarm,
tamper alarms, low battery or mains failure
reports, and it can also (by user number) identify
the users who Arm and Disarm the system.
Central Station Monitoring is highly
recommended and is the most effective method
of monitoring your D8 alarm system. For further
information about 24 hour monitoring, contact
your installer or Ness Security Products.
MONITORING
MONITORED
PREMISES
CENTRAL STATION MONITORING
TELEPHONE LINE
MONITORING
STATION

Ness D8 Specifications

General

Brand	Ness
Model	D8
Category	Control Panel
Language	English