Ness D8 - PROGRAMMING

NESS D8 V4.7 CONTROL PANEL - USER MANUAL
21
PROGRAMMING
[Master Code]
[Master Code]
ENTER
To enter PROGRAM MODE
ENTER
To exit PROGRAM MODE
Various system options can be programmed
by the user. These options can only be
accessed from Program Mode.
User Codes may need to be re-programmed
if a person has forgotten their code, to give
a new user access to the system or to give
someone temporary access.
User Codes 2-15 can be set as Arm Only
Codes. These codes can Arm but cannot
Disarm the panel. (Useful for assigning to
cleaners, tradesmen etc.)
You may need to change the Entry and Exit
timers if you fi nd the delays are too long or
short.
If Audible Monitoring is programmed by your
installer, the ‘Follow Me’ Telephone Number
is the telephone number the dialler will call in
the event of an alarm.
If your Ness D8 panel is monitored by a
Central Station, the Follow Me number is
ignored.
For all other programming changes, talk to
your installer.
The panel will automatically exit Program
Mode is no buttons are pressed within a
4 minute period.
The factory default
Master Code is: 123