10
The Home Screen
III. THE HOME SCREEN
Cable: When the cable is connected un-terminated, or is connected to a WireView
TM
Cable ID, this shows cable information or wire mapping
information. This feature can also be used to locate a cable with the optional Fluke Networks* IntelliTone
TM
Probe.
The name of the tester profile. A profile contains the tester configuration settings. The default name is “Untitled”. An asterisk appears to the
right of the name if you have changed a setting on the tester since you loaded or saved the profile.
AutoTest: Use AutoTest to Ping and connect to selected targets. Up to 10 targets can be entered as a URL or IPv4/ IPv6 address along with the
optional port number. When no port is specified, a Ping is performed. When the port
is specified, a TCP SYN/ACK is performed. This is also
To Next Page
Loading...
