netAlly LinkRunner AT 1000 User Manual

Additional LinkRunner Tools
23
• PoE Configuration:
Enable PoE: Disabled
Class: Class 1
• Connect Configuration: Security: Disabled
Speed & Duplex: Auto
• General Configuration: Reporting Mode: Local
Cable Unit: Meters
Manage Power: Enabled
• Set Language:
English
When you select Restore Factory Defaults, you will be prompted
with a popup. Select OK, then press L.
The tester turns off once it is finished restoring.
Update Firmware
1 Download the LinkRunner firmware update file from the
NetAlly website (http://NetAlly.com/products/ LinkRunner),
or contact NetAlly to get the update by other means.
2 Save the file to your hard disk.
3 Get the latest version of LinkRunner Manager from the NetAlly
website shown in number 1.
4 Start LinkRunner Manager on your PC.
5 Turn on the tester.
6 Select Tools > Firmware Update > select Update.
7 Use the USB cable supplied with the tester to connect the
tester to the PC.
8 In LinkRunner Manager, select LinkRunner > Update Software.
9 Click Select, find and select the update file (.zip extension), then
click Select.
10 Click Update.
Caution
Do not disconnect the LinkRunner from the PC or remove the
battery during the update.
11 When the transfer is completed, disconnect the USB cable from
the tester.
12 The screen on the tester goes blank while it installs the update
file. When the update is completed, restart the tester.
Transfer Saved Profiles to/from LinkRunner Manager
Use LinkRunner Manager to view and configure the profiles that are
saved on the tester.
To transfer profiles from the tester to LinkRunner Manager
1 Install the latest version of LinkRunner Manager software on
your PC.

netAlly LinkRunner AT 1000 Specifications

General

Brand	netAlly
Model	LinkRunner AT 1000
Category	Test Equipment
Language	English