netAlly LinkRunner AT 1000 - Using the PoE Feature

Using the PoE Feature
27
Figure 18. Cable Test Results
IX. USING THE POE FEATURE
Power over Ethernet (PoE) is disabled by default. To enable
PoE, select Tools > PoE Configuration, and check Enable PoE. Select
the Power Sourcing Equipment (PSE) class to verify.
If the LinkRunner AT is a 2000 model, you also have the option of
enabling TruePower™. TruePower applies a load equivalent to the
selected class to mimic a Powered Device (PD). See Figures 19 and
20.
Figure 19. PoE Configuration on LR-AT model 1000
Figure 20. PoE Configuration on LR-AT model 2000