netAlly LinkRunner AT 1000 - Setting Up the Tester; IP Configuration

Setting Up the Tester
16
VI. SETTING UP THE TESTER
To change settings on the tester, select Tools from the home IP Configuration screen.
Select Tools > IP Configuration.
Figure 4. Tools Menu Figure 5. IP Configuration Screen
This screen allows you to enter an IPv4 address or use a DHCP
address (default). It also allows you to enable IPv6 addressing (2000
model only). LR-AT uses the IP address during AutoTest. During
AutoTest, the LR-AT is required to connect to the network for Ping
and TCP Connectivity testing.