13
Does this RJ-45 port support PoE?
Use Tools to specify the desired PoE power class and use Switch or
AutoTest to verify the power under load up to 25.5 W (802.3at).
What speed/duplex is this device configured for?
Use Switch to check the advertised and actual speed/duplex.
Additionally, use Tools to test for manual (non-Auto Negotiated)
speed/duplex.
Can I see traffic from this connection?
Observe the utilization LED blinking to see network traffic.
Can I connect in a MAC access control environment? Use Tools >
VLAN/MAC/Proxy Configuration to specify a user defined MAC
address.
Do I have network connectivity?
Select AutoTest to validate key network services (DHCP, DNS,
Router).
Can I get an IPv4 DHCP address?
Select AutoTest. Select DHCP (or enter a static IP address) in the
Tools > IP Configuration menu.
Can I get an IPv6 address?
Enable IPv6 in Tools > IP Configuration. Use AutoTest to observe the
acquired IPv6 link-local and global address.
Common Questions LinkRunner AT Can Answer
Can I PING?
Select AutoTest. Configure an address to Ping under Tools > AutoTest
Configuration.
Can I verify application connectivity?
To Next Page
Loading...
