UPM 2000
Netech Corporation
110 Toledo St, Farmingdale, NY 11735
http://www.Netech.org
11
1-800-547-6547
Immunity
The system has been type tested by an independent, accredited testing laboratory
and found to meet the latest harmonized European emissions and immunity
standard requirements of EN 61326 for commercial measurement equipment.
Verification of compliance was conducted to the limits and methods of the
following:
EN 61326-1 IAW EN 61000-4-2 Electrostatic Discharge
EN 61326-1 IAW EN 61000-4-3 Annex D Radiated & Conducted EM
EN 61326-1 IAW EN 61000-4-4 Electrical Fast Transient/Burst
EN 61326-1 IAW EN 61000-4-5 Surge Immunity
EN 61326-1 IAW EN 61000-4-6 Conducted Disturbances
EN 61326-1 IAW EN 61000-4-11 Voltage Interrupts
EC Directive 73/23/EEC Low Voltage (User Safety)
The system has been type tested by an independent testing laboratory and found
to meet the requirements of EC Directive 73/23/EEC for Low Voltage.
Verification of compliance was conducted to the limits and methods of the
following:
EN 61010-1
“Safety Requirements for Electrical Equipment for Measurement, Control and
Laboratory Use, Part 1: General requirements” (including amendments 1 & 2).
To Next Page
Loading...
Need help?
General
