UPM 2000
Netech Corporation
110 Toledo St, Farmingdale, NY 11735
http://www.Netech.org
42
1-800-547-6547
Retur
The UPM ed
to Netech. Call Netech Customer Service at 1-800-547-6547 (U.S.) or 1-631-531-0100
(Interna and shipping instructions.
For reca ing
procedu
Battery Replacement
al times and turns off shortly after it is
turned on, the battery is low and should be replaced. Be aware that when
open the
hinged plastic b
battery compartme
Storage
000 must be stored in an upright position on a flat surface that is relatively
ation. T e unit should be stored in the carrying bag supplied with the
ee of dust and other foreign particles.
The UPM 2000 must have the cone removed and be fully drained for
storage. Permanent damage may result if this is not done.
The UPM 2000 can be stored under the following environmental
conditions:
Temperatu
Humidity: tive humidity
The UPM 2000 -
densation within th
vapors.
ning the UPM 2000 for Recalibration
2000 should be recalibrated annually. The instrument should be return
tional) to obtain a Return Authorization Number
libration, pack the UPM 2000 according to the Repackaging and Shipp
res outlined in this chapter. Failure to do so may void warranty.
When the display blinks sever
the unit is running on battery, it will shut down within 8-10 minutes
automatically, when not being actively used. If the battery is low, it will
shut down within seconds of turning on. The alkaline battery (9 V
Duracell MN 1604 or equivalent) must be replaced or alternatively a wall
mounted transformer unit may be used. To replace the battery,
attery cover on the instrument's back panel to expose the
nt. Replace the battery, and close the battery cover.
The UPM 2
free of vibr
unit. The storage environment should be fr
h
re: 5
O
-40
O
C (41.3
O
-106.4
O
F)
up to 90% rela
should be protected from temperature extremes that can cause con
e unit and should be stored away from corrosive fumes and
To Next Page
Loading...
Need help?
General
