UPM 2000
Netech Corporation
110 Toledo St, Farmingdale, NY 11735
http://www.Netech.org
9
Hazard Warnings
∗ Warning! Power Rating. The UPM 2000’s mains power input must be connected
to an external power transformer that provides voltage and current within the
specified rating for the system.
Use of an incompatible power transformer may produce electrical shock and
fire hazards. See Specifications and Optional Accessories in Chapter 2.
∗ Warning! Internal Voltage. Always turn off the power switch and unplug the
power cord before cleaning the UPM 2000’s outer surface.
∗
Warning! Liquids. Avoid spilling liquids on the analyzer; fluid seepage into
internal components creates a potential shock hazard. Do not operate the
instrument if internal components are exposed to fluid.
Precautions
The following precautions are provided to help you avoid damaging the system:
∗ Caution: Service. Authorized service personnel should service the UPM 2000.
Only qualified technical personnel should perform troubleshooting and service
procedures on internal components.
∗ Caution: Environmental Conditions. Do not expose the system to temperature
extremes. Ambient temperatures should remain between 10-30°C operating or
5-40°C storage. System performance may be adversely affected if temperatures
fluctuate above or below this range.
∗ Caution: Do Not Immerse. Clean only with a mild detergent, and wipe down
with a gentle cloth.
1-800-547-6547
To Next Page
Loading...
Need help?
General
