UPM 2000
Netech Corporation
110 Toledo St, Farmingdale, NY 11735
http://www.Netech.org
43
Repackaging and Shipping
When the UPM 2000 is shipped to Netech for service or repair, the unit must be
shipped in the original packing and carrying case; other forms of commercially
available packing are not recommended and can void the warranty.
If the original p
packing.
Repackage the
Figure 4-1
x in
niversal transducer clamp from the clamp support post.
nk. Remove the cone hanger
ight side
Unscrew the transducer clamp support bar. Store it in front pocket of the
carrying bag.
acking has been damaged or lost, contact Netech for replacement
instrument according to the following procedures:
1-800-547-6547
Figure 4-1
Unplug the wall transformer from the unit, if used. Store it in its bo
the left pocket, as shown in Figure 4-1.
Remove the u
Store in front pocket of carrying bag along with the hook clamp.
Remove all the centering rings from the ta
from the tank. Store the centering rings and cone hanger in r
pocket of the carrying bag.
Calibration Check
Weight
Transformer Shipping
Box Pocket
Calibration We
Adap
ight
ter Pedestal
Universal Transducer
Clamp
Centering Rings
Clamp Support
Post
Clamp Hook
Cone Hanger
To Next Page
Loading...
Need help?
General
