Security Gateway Manual Netgate-4200
2.5.6 Gateway Groups
Gateway Groups do not control traffic directly, but can be used in other places, such as firewall rules and service
bindings, to influence how those areas use gateways.
For most scenarios it helps to create three gateway groups to start with: PreferWAN, PreferWAN2, and LoadBalance:
• Navigate to System > Routing, Gateway Groups tab
• Click Add to create a new gateway group
• Configure the group as follows:
Group Name
PreferWAN
Gateway Priority
Gateway for WAN on Tier 1, Gateway for WAN2 on Tier 2
Description
Prefer WAN, fail to WAN2
• Click Save
• Click Add to create another gateway group
• Configure the group as follows:
Group Name
PreferWAN2
Gateway Priority
Gateway for WAN on Tier 2, Gateway for WAN2 on Tier 1
Description
Prefer WAN2, fail to WAN
• Click Save
• Click Add to create another gateway group
• Configure the group as follows:
Group Name
LoadBalance
Gateway Priority
Gateways for WAN and WAN2 both on Tier 1
Description
Load Balance Connections on WAN and WAN2
Note: Rules using this group enable connection-based load balancing, not per-packet load balancing.
Rules using this group will also have failover style behavior as WANs which are down are removed from load
balancing.
• Click Save
• Click Apply Changes
Now set the default gateway to a failover group:
© Copyright 2024 Rubicon Communications LLC 51
To Next Page
Loading...
