Security Gateway Manual XG-7100
Fig. 6: Configure WAN Interface page in the Setup Wizard
1.2.3 Finishing Up
After completing or exiting the wizard, during the first time loading the Dashboard the firewall will display a notifi-
cation modal dialog with the Copyright and Trademark Notices.
Read and click Accept to continue to the dashboard.
If the Ethernet cable was unplugged at the beginning of this configuration, reconnect it to the ETH1 port now.
This completes the basic configuration for the Netgate appliance.
© Copyright 2024 Rubicon Communications LLC 9
To Next Page
Loading...
