Security Gateway Manual XG-7100
Description
Prefer WAN, fail to WAN2
• Click Save
• Click Add to create another gateway group
• Configure the group as follows:
Group Name
PreferWAN2
Gateway Priority
Gateway for WAN on Tier 2, and WAN2 on Tier 1
Description
Prefer WAN2, fail to WAN
• Click Save
• Click Add to create another gateway group
• Configure the group as follows:
Group Name
LoadBalance
Gateway Priority
Gateways for WAN and WAN2 both on Tier 1
Description
Prefer WAN2, fail to WAN
Note: This performs connection-based load balancing, not per-packet load balancing.
• Click Save
• Click Apply Changes
Now set the default gateway to a failover group:
• Navigate to System > Routing, Gateways tab
• Set Default gateway IPv4 to PreferWAN
• Click Save
• Click Apply Changes
Note: This is important for failover from the firewall itself so it always has outbound access. While this also enables
basic failover for client traffic, it’s better to use policy routing rules to control client traffic behavior.
© Copyright 2024 Rubicon Communications LLC 54
To Next Page
Loading...
