Security Gateway Manual XG-7100
Destination
This Firewall (self)
Description
Reject all other traffic to the firewall
• Click Save
Add rule to reject traffic from this network to private networks
• Click to add a new rule at the bottom of the list.
• Configure the rule as follows:
Action
Reject
Interface
OPTx (or the custom name)
Protocol
Any
Source
Any
Destination
Single Host or Alias, PrivateNets (the alias created earlier)
Description
Reject all other traffic to private networks
• Click Save
Add rule to pass from this interface network to any destination:
• Click to add a new rule at the bottom of the list.
• Configure the rule as follows:
Action
Pass
Interface
OPTx (or the custom name)
Protocol
Any
Source
OPTx Net (or the custom name)
Destination
Any
Description
Default allow all from OTPx
• Click Save
With the rules all in place, now click Apply Changes to finish and activate the new rules.
After the configuration, the rules should look like the following figure:
© Copyright 2024 Rubicon Communications LLC 63
To Next Page
Loading...
