NETGEAR CM500V User Manual

• Power On/Off button. Press the Power On/Off button to provide power to the cable modem.
• DC power connector. Connect the power adapter that came in the product package to the DC power
connector.
• Tel 1 and 2 ports. Connect your phone line to the Tel 1 port.
The Tel 2 port works only for a two-phone-line subscription.Note
• Ethernet port. For installation and activation, connect a computer to this port. After you install the cable
modem and activate your Internet service, you can disconnect the computer and connect a router to
this port.
• Reset button. Pressing the Reset button resets the cable modem. If the Reset button is pressed for
at least seven seconds, the Power LED blinks green and the cable modem returns to its factory settings.
• Coaxial cable port. Connect the cable port to a cable wall outlet.
Label
The cable modem label shows the login information, MAC address, and serial number.
Figure 4. Cable modem label
System Requirements
You need the following to install your cable modem:
• Compatible operating system:
- Windows 7
- Windows 8
- Windows 10
- Windows Vista
- Windows XP
- Windows 2000
Hardware Setup
9
Voice Cable Modem

NETGEAR CM500V Specifications

General

Product color	Black
DC-in jack	Yes
Modem (RJ-11) ports	2
Ethernet LAN (RJ-45) ports	1
Cables included	LAN (RJ-45), Phone (RJ-11)