NETGEAR VPN Configuration
152
N300 Wireless Dual Band ADSL2+ Modem Router DGND3300v2
Step 1: Configure Gateway A (the NETGEAR VPN Router at the
Main Office)
To configure the VPN tunnel:
1. Log in to the VPN router. Select VPN Policies to
display the VPN Policies screen. Click
Add Auto Policy to proceed and enter the information.
toGW_A.com (in this example)
fromGW_A.com (in this example)
fromGW_A (in the example)
192.168.2.3 (in this example)
IKE Keep Alive is optional; has to match
Remote LAN IP Address when enabled
(remote computer has to respond to pings)
(Remote NAT router has to have
Address Reservation set and
VPN Passthrough enabled)
2. Click Apply when you are finished to display the VPN Policies screen.
To Next Page
Loading...
Need help?
General
