Factory Settings and Technical Specifications
72
AC1900 Nighthawk WiF Mesh Extender
Factory Default Settings
To reset the extender to factory default settings, you can use either the Reset button on the
rear panel or the Erase function. For more information, see Return the Extender to Its Factory
Default Settings on page 43.
The following table shows the factory default settings.
Table 5. Factory default settings
Feature Default Settings
Smart Setup Enabled
WiFi communication Enabled
WiFi network name (SSID) NETGEAR_EXT
Security Disabled
Transmission speed Auto
1
1. Maximum WiFi signal rate (IEEE Standard 802.11). Actual throughput can vary. Network conditions and
environmental factors, including volume of network traffic, building materials and construction, and network
overhead lower actual data throughput rate.
Country/region Varies by region
Operating mode 802.11a/b/g/n/ac
Data rate in the 2.4 GHz band Up to 600 Mbps
Data rate in the 5 GHz band Up to 1300 Mbps
DHCP Client enabled
To Next Page
Loading...
Need help?
General
