NETGEAR FVS124G User Manual

Enable Mode Config in VPN Tracker
#
21
Advanced Users It is very important to initially set up Mode Config as “automatic” instead of “active” or “passive”. While this
may mean a short delay when connecting (if the device actually requires “active” mode config), it will
ensure that it works in both cases. You can later try passive or active to see which mode your device and
particular firmware revision actually uses
‣
Check “Mode Config” in the “Network Configuration”
section. If you cannot find this setting for your device,
make sure you have selected the correct device and
firmware revision

NETGEAR FVS124G Specifications

Power

power requirements	12V DC, 1.2A

System Memory

processor	200 MHz 32-bit RISC
memory	4MB Flash, 16MB DRAM

Ports & Interfaces

LAN ports	Four (4) 10/100/1000 Mbps auto-sensing, AutoUplink RJ-45 ports
WAN ports	Two (2) 10/100Mbps Ethernet RJ-45 ports

Weight and Dimensions

dimensions	7.45 x 4.85 x 1.26 in. (18.92 x 12.31 x 3.19 cm)
weight	1.37 lbs. (0.62 kg)