NETGEAR GC110 User Manual

Manage Device Security
209
Insight Managed 8-Port Gigabit Ethernet Smart Cloud Switch with 2 SFP Fiber Ports
The TACACS+ Configuration page displays.
6. In the Key String field, specify the authentication and encryption key for TACACS+
communications between the switch and the TACACS+ server.
The valid range is 0–128. The key must match the key configured on the TACACS+
server.
7. In the Connection Timeout field, specify the maximum number of seconds allowed to
establish a TCP connection between the switch and the TACACS+ server.
The valid range is 1–30 seconds. The default is 5 seconds.
8. Click the Apply button.
Your settings are saved.
Configure a TACACS+ Server on the Switch
Use the TACACS+ Server Configuration page to configure up to five TACACS+ servers with
which the switch can communicate.
 To configure a TACACS+ server on the switch:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see Access the Switch on page 11.
The login window opens.
4. Enter the switch’s password in the password field.
The default password is password. If you added the switch to a network on the Insight
app before and you did not yet change the password through the local browser interface,
enter your Insight network password.
The System Information page displays.
5. Select Security > Management Security> TACACS+ > TACACS+ Server Configuration.
The TACACS+ Server Configuration page displays.
6. In the TACACS+ Server field, enter the TACACS+ server IP address.
7. In the Priority field, specify the priority for the TACACS+ server.
The priority determines the order in which the TACACS+ servers are contacted when
attempting to authenticate a user. A value of 0 is the highest priority. The valid range is
0–65535.
8. In the Port field, specify the authentication port value for TACAS+ server sessions. It must
be within the range 0–65535. If you do not specify a value, the switch uses the standard
TCP port 49 for sessions with the server.

NETGEAR GC110 Specifications

General

Switch type	Managed
Quality of Service (QoS) support	Yes
Console port	RJ-45
Power connector	DC-in jack
SFP module slots quantity	2
Installed SFP modules quantity	-
Basic switching RJ-45 Ethernet ports type	Gigabit Ethernet (10/100/1000)
Basic switching RJ-45 Ethernet ports quantity	8
Product color	Gray
10G support	No
MAC address table	- entries