NETGEAR GC110 User Manual

Hardware Specifications and Default Values
364
Insight Managed 8-Port Gigabit Ethernet Smart Cloud Switch with 2 SFP Fiber Ports
Switch Specifications
The switch conforms to the TCP/IP, UDP, HTTP, ICMP, TFTP, DHCP, IEEE 802.1D, IEEE
802.1p, and IEEE 802.1Q standards.
Table 79. Switch Specifications and Performance
Feature Value
GC110 Eight 10/100/1000Mbps
Two 10G/1G SFP+ ports
GC110P Eight PoE 10/100/1000Mbps
Two 10G/1G SFP+ ports
GC510P Eight PoE+ 10/100/1000Mbps
Two 10G/1G SFP+ ports
GC510PP Eight High-Power PoE+ 10/100/1000Mbps
Two 10G/1G SFP+ ports
Flash memory size 32 MB NOR
SRAM size and type 256 MB DDR3 SDRAM
Switching capacity Non-Blocking Full WireSpeed on all packet sizes
Forwarding method Store and Forward
Packet forwarding rate 10M:14,880 pps
100M:148,810 pps
1G:1,488,000 pps
MAC addresses 16K
Switch Features and Defaults
The tables in this section provide information about the switch features and default values.
Table 80. Feature Default Values and Default State
Feature Name/Parameter Default
DHCP L2 Relay
Global
Admin Mode Disabled
VLAN
Admin Mode Disabled
Circuit ID Mode Disabled

NETGEAR GC110 Specifications

General

Switch type	Managed
Quality of Service (QoS) support	Yes
Console port	RJ-45
Power connector	DC-in jack
SFP module slots quantity	2
Installed SFP modules quantity	-
Basic switching RJ-45 Ethernet ports type	Gigabit Ethernet (10/100/1000)
Basic switching RJ-45 Ethernet ports quantity	8
Product color	Gray
10G support	No
MAC address table	- entries