Monitor the System
346
Insight Managed 8-Port Gigabit Ethernet Smart Cloud Switch with 2 SFP Fiber Ports
The System Information page displays.
5. Select Monitoring > Mirroring > Port Mirroring.
The Global Configuration page displays.
6. Select an Admin Mode radio button:
• True. Port mirroring is enabled.
• False. Port mirroring is enabled.
7. From the Destination Port menu, select the destination port to which port traffic must be
copied.
You can configure only one destination port on the system. The port functions as a probe
port and receives traffic from all configured source ports. If no port is configured, None is
displayed. The default is None.
Perform the following steps in the Source Interface Configuration section.
8. Use one of the following methods to narrow down the ports that are displayed:
• Select 1 to display the physical ports of the selected unit.
• Select LAG to display a list of LAGs only.
• Select CPU to display a list of CPUs only.
• Select All to display a list of all physical ports, LAGs, CPUs, and VLANs.
9. Use one of the following methods to select one or more source ports:
• Select a specific interface by specifying the interface number using the respective
naming convention (for example, g1 or l1) in the Go To Interface field and clicking the
Go button. See
Interface Naming Conventions on page 10 for more information. The
entry corresponding to the specified interface is selected.
• Select one or more check boxes in the Interface column.
10. From the Direction menu, specify the direction of the traffic that must be mirrored from the
selected source ports:
• None. The value is not configured. This is the default setting.
• Tx and Rx. Monitors transmitted and received packets.
• Rx. Monitors received (ingress) packets only.
• Tx. Monitors transmitted (egress) packets only.
11. Click the Apply button.
Your settings are saved. Traffic from the selected ports is sent to the probe port.
The Status field indicates the interface status.
To Next Page
Loading...
Need help?
General
