Table 2. LEDs on the front panel of model GS710TUP (Continued)
DescriptionLED
Solid green. A valid 1 Gbps port link is established.
Blinking green. The port is transmitting or receiving packets at 1 Gbps.
Solid amber. A valid 10 Mbps or 100 Mbps port link is established.
Blinking amber. The port is transmitting or receiving packets at 10 Mbps or 100 Mbps.
Off. No port link is established.
Port 9 LED
Link, speed, and activity for
Ethernet uplink port 9
Off. No SFP module link is established.
Solid green. A valid 1 Gbps link is established.
Blinking green. The SFP fiber port is transmitting or receiving packets at 1 Gbps.
Port 10 LED
Link and activity for SFP fiber
uplink port 10
Model GS710TUP back panel
The back panel of model GS710TUP contains a Kensington lock slot for an optional
security cable and an AC power receptacle for the AC power cable that came in the
switch package.
The following figure shows the back panel of model GS710TUP.
Figure 4. Model GS710TUP back panel
Switch hardware interfaces
The following sections describe the hardware interfaces on the switch.
RJ-45 ports for 10/100/1000M BASE-T Ethernet connectivity
All RJ-45 copper ports support autosensing. When you insert a cable into an RJ-45 port,
the switch automatically ascertains the maximum speed (10 Mbps, 100 Mbps, or 1 Gbps)
and duplex mode (half-duplex or full-duplex) of the attached device. All ports support
a Cat 5e cable (or higher-rated Ethernet cable) terminated with an 8-pin RJ-45 connector.
To simplify the procedure for attaching devices, all RJ-45 ports support Auto Uplink
technology. This technology allows attaching devices to the RJ-45 ports with either
straight-through or crossover cables.
Hardware Installation Guide17Hardware Overview
10-Port Gigabit Ethernet Ultra60 PoE++ Smart Managed Pro Desktop and Rackmount Switches
To Next Page
Loading...
