Overview
Model GS110TUP provides eight 10/100/1000BASE-T RJ-45 copper ports. Ports 1–4
support PoE++ and ports 5–8 support PoE+.
Model GS710TUP provides eight 10/100/1000BASE-T RJ-45 copper PoE++ ports (1–8).
Both models provide one RJ-45 copper uplink port (9). All RJ-45 copper ports support
nonstop 10/100/1000M Layer 2 networks. In addition, both models provide one SFP
uplink port (10), which can accept a small form-factor pluggable (SFP) gigabit interface
converter (GBIC) for 1G fiber connectivity. Both uplink ports (9 and 10) are intended for
a network connection and, therefore, do not provide PoE.
You can use the switch to connect PoE++, PoE+, PoE, and non-PoE devices.
Note: For information about application samples, see Applications on page 20.
You can install the switch freestanding or rack mounted in a wiring closet or equipment
room. The switch is IEEE compliant and offers low latency. All ports can automatically
negotiate to the highest speed, which makes the switch very suitable for a mixed
environment with Fast Ethernet and Gigabit Ethernet.
Use Category 5e (Cat 5e) or higher-rated Ethernet cables terminated with RJ-45
connectors to make Gigabit connections.
Features
The switch supports the following key hardware features:
•
Four (model GS110TUP) or eight (model GS710TUP) 10/100/1000BASE-T RJ-45
copper ports that can provide PoE++ (IEEE 802.3bt).
•
For model GS110TUP, four 10/100/1000BASE-T RJ-45 copper ports that can provide
PoE+ (IEEE 802.at).
•
One RJ-45 copper uplink port.
•
One SFP fiber uplink port.
•
Total PoE++ power budget:
- For model GS110TUP, 240W across all active PoE++ and PoE+ ports.
- For model GS710TUP, 480W across all active PoE++ ports.
•
MAC table size of 8K.
•
20 Gbps full-duplex, nonblocking switch fabric.
Hardware Installation Guide6Introduction
10-Port Gigabit Ethernet Ultra60 PoE++ Smart Managed Pro Desktop and Rackmount Switches
To Next Page
Loading...
