GS700TS Smart Switch Software Administration Manual
Configuring Switching Settings 4-6
v1.0, June 2009
– Enable – Reactivates the suspended LAG.
– Disable – Does not reactivate the suspended LAG.
• Type – Displays the LAG type. The possible field values are:
– Static – Indicates the LAG is configured manually.
– LACP – Indicates the LAG is configured automatically.
• Speed – Select the data transmission rate for the LAG. The LAG type determines what
speed setting options are available. The possible field values are:
– 10M – Indicates the LAG is currently operating at 10 Mbps.
– 100M – Indicates the LAG is currently operating at 100 Mbps.
– 1000M – Indicates the LAG is currently operating at 1000 Mbps.
• Duplex Mode – Displays the duplex mode of the LAG. The possible field values are:
– Full – Indicates the interface supports transmission between the device and its link
partner in both directions simultaneously.
– None – Indicates Duplex mode is not enabled on the LAG.
• Auto Negotiation – Select the auto negotiation status of the LAG. Auto Negotiation is a
protocol between two link partners that enables a port to advertise its transmission rate and
flow control abilities to its partner. Auto Negotiation is enabled by default. The possible
field values are:
– Enable – Enables auto negotiation.
– Disable – Disables auto negotiation.
• Flow Control – Select the flow control status of the LAG. Operates when the LAG is in
full duplex mode. Flow Control is disabled by default. The possible field values are:
– Enable – Enables flow control.
– Disable – Disables flow control.
2. Select the interface.
3. Enter or modify the fields in the first row.
4. Click APPLY to update the device.
To Next Page
Loading...
Need help?
General