NETGEAR GS748T GS748T GS748T User Manual

GS748T Smart Switch Hardware Installation Guide
Installation 4-3
v1.0, January 2007
4. Support the weight of the switch and use four pan-head screws with nylon washers to attach it
to the rack; use a #2 Phillips screwdriver to tighten the screws.
Figure 4-1 Mounting the Switch in a Rack
Step 3: Checking the Installation
Before you apply power, inspect the equipment thoroughly to:
• Verify that all cables are installed correctly.
• Check that cables are not damaged and that cable routing does not interfere with equipment to
create a safety hazard.
• Ensure that all equipment is mounted properly and securely.
Step 4: Connecting Devices to the Switch
The following procedure describes how to connect devices to the switch’s RJ-45 ports. Your
NETGEAR GS748T Gigabit Smart Switch contains Auto Uplink technology, which enables you
to attach devices using either straight-through or crossover cables.

NETGEAR GS748T GS748T GS748T Specifications

General

Model Number	GS748T
Product Type	Switch
Ports	48
SFP Ports	4
Form Factor	Rack-mountable
Layer	Layer 2
Switching Capacity	96 Gbps
Forwarding Rate	71.4 Mpps
MAC Address Table Size	16K
Jumbo Frame Support	Yes
VLAN Support	Yes
Number of VLANs	256
Quality of Service (QoS)	Yes
PoE	No
Stackable	No
Port Type	Gigabit Ethernet
Management	Yes
Operating Temperature	32°F to 104°F (0°C to 40°C)
Storage Temperature	-4°F to 158°F (-20°C to 70°C)
Humidity	90% maximum relative humidity, noncondensing