NETGEAR GS748T GS748T GS748T User Manual

GS748T Smart Switch Hardware Installation Guide
4-4 Installation
v1.0, January 2007
Figure 4-2 Connecting Devices to the Switch
Connect each device to an RJ-45 network port on the switch’s front panel (see Figure 4-2) using a
Category 5 (Cat5) unshielded twisted-pair (UTP) cable with RJ-45 connectors.
Step 5: Installing a SFP GBIC Module
The following procedure describes how to install an optional SFP GBIC module into one of the
SFP GBIC module bays of the switch.
To install a SFP GBIC module, insert the SFP module into the SFP GBIC module bay. Press firmly
on the flange of the module to seat it securely into the connector.
You can install up to three additional Gigabit Ethernet modules using this procedure.
Note: Ethernet specifications limit the cable length between the switch and the attached
device to 100 m (328 ft.).
Note: Contact your NETGEAR sales office to buy these modules. If you do not want to
install a SFP GBIC module, skip this procedure.

NETGEAR GS748T GS748T GS748T Specifications

General

Model Number	GS748T
Product Type	Switch
Ports	48
SFP Ports	4
Form Factor	Rack-mountable
Layer	Layer 2
Switching Capacity	96 Gbps
Forwarding Rate	71.4 Mpps
MAC Address Table Size	16K
Jumbo Frame Support	Yes
VLAN Support	Yes
Number of VLANs	256
Quality of Service (QoS)	Yes
PoE	No
Stackable	No
Port Type	Gigabit Ethernet
Management	Yes
Operating Temperature	32°F to 104°F (0°C to 40°C)
Storage Temperature	-4°F to 158°F (-20°C to 70°C)
Humidity	90% maximum relative humidity, noncondensing