NETGEAR GS748T GS748T GS748T User Manual

GS748T Smart Switch Hardware Installation Guide
Installation 4-5
v1.0, January 2007
Figure 4-3 Installing a SFP GBIC Module into GS748T
Step 6: Applying AC Power
Because he NETGEAR GS748T Gigabit Smart Switch has no ON/OFF switch, AC power must be
controlled by means of the IEC power cord connection. Select an appropriate unswitched,
grounded AC facility outlet so as to avoid any future inadvertent power interruptions. Use the
following procedure to apply AC power:
1. Connect the female end of the supplied IEC AC power adapter cable to the power receptacle
on the back of the switch.
2. Connect the 3-pronged end of the AC power adapter cable to the AC outlet.
When you apply power, the green Power LED on the switch front panel illuminates.
.
Note: If the Power LED does not light, check that the power cable is installed correctly
and that the AC power supply is present. If this does not resolve the problem, refer
to
Appendix A, “Troubleshooting”.

NETGEAR GS748T GS748T GS748T Specifications

General

Model Number	GS748T
Product Type	Switch
Ports	48
SFP Ports	4
Form Factor	Rack-mountable
Layer	Layer 2
Switching Capacity	96 Gbps
Forwarding Rate	71.4 Mpps
MAC Address Table Size	16K
Jumbo Frame Support	Yes
VLAN Support	Yes
Number of VLANs	256
Quality of Service (QoS)	Yes
PoE	No
Stackable	No
Port Type	Gigabit Ethernet
Management	Yes
Operating Temperature	32°F to 104°F (0°C to 40°C)
Storage Temperature	-4°F to 158°F (-20°C to 70°C)
Humidity	90% maximum relative humidity, noncondensing