Step 2: Protect against electrostatic
discharge
WARNING: Static electricity can harm delicate components inside your system. To
prevent static damage, discharge static electricity from your body before you touch any
of the electronic components, such as the microprocessor. You can do so by periodically
touching an unpainted metal surface on the switch.
You can also take the following steps to prevent damage from electrostatic discharge
(ESD):
•
When unpacking a static-sensitive component from its shipping carton, leave it in
the antistatic package until you are ready to install it. Just before unwrapping the
antistatic package, discharge static electricity from your body.
•
Before moving a sensitive component, place it in an antistatic container or package.
•
Handle all sensitive components in a static-safe area. If possible, use antistatic floor
pads, workbench pads, and an antistatic grounding strap.
Step 3: Unpack the switch
The following figure shows the package contents for the switch. The figure shows the
contents for model M4250-10G2XF-PoE++, but the contents for all models are the very
similar, other than the switch model. Any differences in contents are listed in the following
table.
Hardware Installation Guide49Installation
AV Line of Fully Managed Switches M4250 Series
To Next Page
Loading...
Need help?
General