Figure 23. Package contents
To check the package contents:
1.
Place the container on a clean flat surface, and cut all straps securing the container.
2.
Unpack the hardware from the boxes by carefully removing the hardware and placing
it on a secure and clean surface.
3. Remove all packing material.
4.
Verify that the package contains the following items:
ItemNumber
Switch of the model that you ordered.
Note: Rubber protection caps are installed in the SFP sockets. If you install an SFP transceiver
module, you must remove the cap from the SFP socket.
1
AC power cable or cables (varies by region).
Note: Model M4250-26G4F-PoE++ comes with two power cables.
Note: Model M4250-40G8XF-PoE++ comes with three power cables.
2
USB console cable.3
Installation guide.4
RJ-45 RS-232 console cable.5
Hardware Installation Guide50Installation
AV Line of Fully Managed Switches M4250 Series
To Next Page
Loading...
Need help?
General