•
AC power receptacle: AC receptacle for the internal PSU. The PSU can accept
100–240V ~ 50–60 Hz, 10A.
•
PSU bays: Two PSU bays (PSU 1 and PSU 2) that are closed with PSU covers. For
information about ordering optional APSs that you can install in the PSU bays, contact
NETGEAR.
LEDs model M4350-48G4XF
This section describes the LED designations of model M4350-48G4XF. The LEDs are
clearly named or numbered on the front and back panels.
Table 4. LEDs of model M4350-48G4XF
DescriptionLED
System LEDs, Front Panel
Solid green: The switch is powered on and operating normally.
Solid yellow: The switch is starting.
Off: Power is not supplied to the switch.
POWER LED
Solid green: The fans are functioning normally.
Solid yellow: One or more fans are malfunctioning.
FAN LED
Off: Sufficient (more than 7W of) PoE power is available.
Solid yellow: Less than 7W of PoE power is available.
Blinking yellow: At least once during the previous two minutes, less than 7W
of PoE power was available.
PoE MAX LED
Solid green: The switch is functioning as the stack management switch.
Off: The switch is functioning as a stack member switch or is not a member of
a stack.
STACK MASTER LED
The Stack LED contains segments that can indicate the stack unit number of the
switch:
Solid green indicating a number: The switch is a member of a stack. The LED
displays the stack unit number.
Solid green indicating E: The switch functions in ECO mode with all port LEDs
turned off.
Off: The switch is not a member of a stack.
STACK ID LED
Hardware Installation Guide24Hardware Overview
Fully Managed Switches M4350 Series
To Next Page
Loading...
Need help?
General